Almost all types of wooden floors are varnished. A layer of lacquer coating allows you to protect the wood from moisture and water, give it a finished appearance, create a pleasant atmosphere in the room. But very often it happens that at the end of the varnishing, the floor does not look at all as we would like, especially if the work is done by an inexperienced master. It's all about non-compliance with the technology of applying varnish, which does not tolerate careless attitude towards itself and provides for compliance with several simple but very important rules.One of the typical mistakes when varnishing surfaces is incorrect coating. The varnish is applied with a roller in cross movements. First, it is completely immersed in the varnish, applied to the floor, and then evenly distributed over its surface.The second most popular mistake is incorrect surface preparation. If you do not remove the remnants of dirt and dust from it, they will most likely end up inside the varnish and spoil its appearance. In this case, it will be necessary to carry out the process of grinding and applying the varnish repeatedly. Therefore, it is desirable to properly clean and prepare the surface from the first time.In the process of applying the varnish coating, bubbles may appear on its surface. Bubbles are formed if the varnish coating is too thick. A strong film is always formed on the surface of such a coating, which prevents the removal of air that is released when the varnish dries. There are two methods of fighting: either put up with the bubbles (if there are a small number of them), or remove the top layer and apply it again.The appearance of white spots on the surface of the parquet is associated with the penetration of an excessive amount of moisture into it. To eliminate this phenomenon, the varnish must be applied at normal air humidity levels.Stripes on the surface of the parquet arise due to interruptions in the process of applying varnish, in which it is applied to the next section already when the previous ones have dried up. Therefore, the entire surface must be varnished at one time.When using a two-component varnish, very often the masters neglect to mix it. As a result, some areas of the floor may acquire a matte shade. In this case, it is necessary to remove the coating and apply it again. Real free porn movies https://exporntoons.net online porn USA, UK, AU, Europe.
